TM 5-3895-382-24
6.
Install piston (43) in spindle (32), and install retaining
ring (46). Do not remove sockethead screws (47) at this
time.
7.
Turn the spindle over.
8.
Install bearing nut (38) on spindle (32). Use Tool (A) to
tighten the bearing nut to a torque of 200 N· m (150 lb-
ft). Mark both the bearing nut and spindle with a
reference line to indicate the minimum final position of
the bearing nut. Remove bearing nut (38).
9.
Use Tool (B) to install duo-cone seal (34) on spindle
(32). Refer to the topic "Assembly & Installation of
Conventional Duo-Cone Seals" in this module for the
correct procedure.
10.
Install bearing cups (26) and (40) in housing (8).
11.
Install bearing cone (27) into bearing cup (26).
12.
Use Tool (B) to install duo-cone seal (28) in housing (B).
Refer to the topic "Assembly & Installation of
Conventional Duo-Cone Seals" in this module for the
correct procedure.
16-33
