TM 5-3895-382-24
Assemble Drum Gear Reducer
(CS-433C & CP-433C) 5655-016
Tools Needed
A
B
126-608
Spanner Socket
1
6Y-6339
Duo-Cone Seal Installation Tool
1
1.
Install nine springs (44) in piston (43). Position thrust
plate (45) on the piston. Install and evenly tighten 11
M5 X 0.8 X 20 mm sockethead screws (47).
2.
Position spindle (32) with the large opening facing
upward. Install end plate (48). six plates (49) and
seven discs (50) inside spindle (32). Make sure the
discs and plates are alternated in the correct sequence.
3.
Install back-up ring (51) in the lower groove in the inside
wall of spindle (32). Install O-ring seal (52) above back-
up ring (51).
4.
Install O-ring seal (41) in the upper groove in the inside
wall of spindle (32). Install back-up ring (42) above O-
ring seal (41).
5.
Apply a light coating of clean grease on the O-ring seals
and backup rings.
16-32