TM 5-3895-382-24
6.
Use the following steps to disassemble shaft assembly
(6).
a.
Remove two bolts (10) from sprocket (8) and bushing
(11). During the final assembly procedure, apply
9S-3263 Thread Lock on the threads of two bolts
(10).
b.
Install two bolts (10) in the two threaded holes,
location (X), of bushing (11).
c.
Tighten two bolts (10), and remove sprocket (8) and
bushing (11) from shaft (9).
7.
Remove one of the bolts that fastens drum support
housing (13) and plate (12) together. Attach a suitable
lifting bracket and Tool (A) as shown.
8.
Remove eight bolts (16), and remove drum support
housing (13) and plate (12) as a unit from the drum
assembly. The weight of the drum support housing and
plate as a unit is approximately 130 kg (286 lb). When
installing, apply 9S-3263 Thread Lock on the threads of
eight bolts (16).
9.
Lower the drum support housing and plate (12) to a
level surface. While supporting the drum support
housing and plate, remove four bolts (17) and support
(18) from both sides of the plate. The weight of each
support is 30 kg (66 lb).
10.
Remove the 16 bolts and four rubber mounts (14) from
supports (10).
11.
To prevent dirt from getting inside the drum support
housing, install the 12 bolts and cover (4) on drum
support housing (13). Position drum support housing
(13) and plate (12) on cover (4).
12.
Remove ten nuts and bolts (15) and Tool (A). Remove
plate (12) from drum support housing (13). The weight
of the plate is 22kg (48 lb). The weight of the drum
support housing is 73 kg (160 lb).
13.
Remove rubber gasket (19) from the bearing housing on
the drum assembly. Check the rubber gasket for wear
or damage and replace if necessary.
NOTE:
For installation of the drum support housing,
revere the removal steps.
End By:
a.
install drum assembly
NOTE:
After the drum support housing has been
installed, fill the housing with oil to the correct
level. See the Operation & Maintenance Manual
for the correct procedure.
16-38
