TM 5-3895-382-24
25.
Apply a light coating of clean grease on O-ring seal (13).
Place the O-ring seal around the rim of housing (8).
26.
Install two dowel pins (7) in the dowel pin holes in
housing (8).
27.
Position ring gear (12) on housing (8), aligning the
dowel pin holes in the ring gear with dowel pins (7).
28.
Position second stage carrier (10) in ring gear (12).
29.
Apply a light coating of clean oil on sun gear (6). Install
the sun gear in second sage carrier (10).
30.
Position first stage carrier (5) on sun gear (6).
31.
Apply a light coating of clean oil on sun gear (3).
Position sun gear (3) in first stage carrier (5).
32.
Apply a light coating of clean grease on thrust washers
(2) and (4). Position the thrust washers on the inside of
cover (1).
33.
Apply a light coating of clean grease on O-ring seal (11).
Place the O-ring seal around the underside of cover (1).
34.
Position cover (1) on ring gear (12), and install 20 bolts.
Tighten the bolts to a torque of 48 to 60 N· m (35 to 45
lb-ft).
35.
Remove 11 M5 X 0.8 X 20 mm sockethead screws (47)
that were installed in the brake assembly during step 1.
End By:
a.
install drum gear reducer (CS-433C & CP-433C)
16-36
