TM 5-3895-382-24
Illustration 86
1.
Remove two bolts (1).
2.
Remove bolt (3).
3.
Remove engine oil relief valve (4) and the gasket.
4.
Disconnect oil tube (2) and remove the O-rings.
Installation Procedure
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
Illustration 87
1.
Connect oil tube (2) and install new O-rings.
2.
Inspect the condition of the gasket. Replace the gasket,
if necessary.
3.
Install engine oil relief valve (4) and the gasket.
4.
Install bolt (3).
5.
Install two bolts (1).
End By:
a.
Install the engine oil pan. Refer to Disassembly and
Assembly, "Engine Oil Pan - Install".
Engine Oil Pump - Remove
SMCS Code: 1304-011
Removal Procedure
Table 13
Required Tools
Tool
Part
Number
Part Description
Qty
A
1P-1855
Retaining Ring Pliers
1
Start By:
a.
Remove the front housing. Refer to Disassembly and
Assembly, "Housing (Front) - Remove".
NOTE:
The engine oil pump is mounted on the No. 1
crankshaft main bearing cap. The engine oil
pump can be removed without removing the front
housing if the No. 1 crankshaft main bearing cap
is removed. Use a 9U-6282 Torque Extension in
order to remove the No. 1 crankshaft main
bearing cap. The engine oil pump is then
removed from the No. 1 crankshaft main bearing
cap.
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
NOTICE
Care must be taken to ensure that fluids are contained
during performance of inspection, maintenance, testing,
adjusting and repair of the product. Be prepared to collect
the fluid with suitable containers before opening any
compartment or disassembling any component containing
fluids.
Refer to Special Publication, NENG2500, "Caterpillar Tools
and Shop Products Guide" for tools and supplies suitable
to collect and contain fluids on Caterpillar products.
Dispose of all fluids according to local regulations and
mandates.
7-38
