TM 5-3895-382-24
Illustration 82
Typical example
1.
Loosen two hose clamps (1) and disconnect the hoses.
2.
Remove three bolts (2).
3.
Remove nut (3) that holds the hose clamp and move the
hose clamp.
4.
Remove engine oil filter base (4) from the engine block.
Plug all openings immediately.
Engine Oil Filter Base - Disassemble
SMCS Code: 1306-015
Disassembly Procedure
Start By:
a.
Remove the engine oil filter base. Refer to
Disassembly and Assembly, "Engine Oil Filter Base -
Remove".
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
NOTICE
Care must be taken to ensure that fluids are contained
during performance of inspection, maintenance, testing,
adjusting and repair of the product. Be prepared to collect
the fluid with suitable containers before opening any
compartment or disassembling any component containing
fluids.
Refer to Special Publication, NENG2500, "Caterpillar Tools
and Shop Products Guide" for tools and supplies suitable
to collect and contain fluids on Caterpillar products.
Dispose of all fluids according to local regulations and
mandates.
Illustration 83
Typical example
1.
Remove engine oil filter (1) from engine oil filter base
(2).
2.
Remove cap (3) from engine oil cooler (4) (if equipped).
3.
Remove engine oil cooler (4) from engine oil filter base
(2), if necessary.
Engine Oil Filter Base - Assemble
SMCS Code: 1306-016
Assembly Procedure
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
7-36
