TM 5-3895-379-23-1
0105
INSTALLATION
NOTE
Ensure gasket surfaces are clean and dry before installation.
Ensure manifold gaskets for front and rear are positioned with notch at top left when
installed on cylinder head. Center gasket can be installed either way.
Do not use any sealant when installing gaskets.
1.
Install two new gaskets (Figure 4, Item 5), new gasket (Figure 4, Item 3), and intake manifold
(Figure 4, Item 7) on cylinder head (Figure 4, Item 2) using four screws (Figure 4, Item 6), screw
(Figure 4, Item 8), and screw (Figure 4, Item 1). Tighten screws to 24 lb-ft (33 Nm).
2.
Connect tube (Figure 4, Item 4) to intake manifold nipple (Figure 4, Item 10) and tighten nut (Figure 4, Item 9)
to 35-71 lb-ft (47-96 Nm).
2
1
3
4
10
9
8
NOTCH
7
5
6
M1294SWR
Figure 4. Intake Manifold Installation.
03/15/2011Rel(1.8)root(maintwp)wpno(M00044)