TM 5-3895-379-10
ADJUST HANDRAILS FOR OPERATION OR STOWAGE
THIS WORK PACKAGE COVERS
Adjust for Operation, Adjust for Stowage
INITIAL SETUP
Equipment Condition
Tools and Special Tools
Wrench, box and open end, combination (Item 5,
Engine off (WP 0005 00)
Roller parked on level ground (WP 0005 00)
Personnel Required
Two
Drums chocked (WP 0005 00)
ADJUST FOR OPERATION
1.
Remove 24 mm wrench from toolbox.
WARNING
Use caution when handling heavy parts. Provide adequate support and use assistance during procedure.
Failure to follow this warning may cause injury.
CAUTION
Failure to hold handrail assembly in place during removal will allow handrail assembly to fall and become
damaged.
2.
While assistant holds left handrail assembly (1), remove two bolts (2) and washers (3) from plate assemblies (4)
using 24 mm wrench.
3.
Lower handrail assembly (1) until holes in handrail align with middle holes in plate assemblies (4).
4.
Install two washers (3) and bolts (2) in middle holes in handrail assembly (1) and plate assemblies (4). Tighten bolts
securely using 24 mm wrench.
5.
Repeat steps 1 through 4 for right handrail.
6.
Stow 24 mm wrench in toolbox.
HANDRAILS
TOOLBOX
POSITIONED
1
FOR
3
2
OPERATION
4
401-2195
