TM 5-3895-379-10
FRONT AND REAR PROPEL GEARBOX OIL CHECK AND SERVICE (CB534B) - CONTINUED
0021 00
FILL
1.
Level check plug (1) is located at 9 o'clock position and fill plug (2) is located at 12 o'clock position.
2.
Turn off engine (WP 0005 00).
3.
Remove fill plug (2), at 12 o'clock position from gearbox (3) through access hole.
WARNING
Oil is very slippery. Immediately wipe up any spills. Failure to follow this warning may cause injury.
CAUTION
Do not overfill propel gearbox. Damage to equipment may result from too much oil in propel gearbox.
NOTE
Use a container to catch any oil that may drain from system. Dispose of oil IAW local policy and ordinances.
4.
Add oil until oil level is at the bottom of the oil level check plug (1) opening. Refer to Oil Level Check in this work
package.
5.
Install fill plug (2) through access hole in gearbox (3).
6.
Move roller until the oil level check plug (1) opening is at 12 o'clock position and fill plug (2) is at 3 o'clock position.
7.
Install oil level check plug (1) through access hole in gearbox (3).
8.
Stow 1/2 in. drive ratchet, 6 in. extension, and 5/16 in. hex bit in toolbox.
END OF WORK PACKAGE
0021 00-3/(0021 00-4 Blank)
