TM 5-3895-379-10
FRONT AND REAR PROPEL GEARBOX OIL CHECK AND SERVICE (CB534B) - CONTINUED
0021 00
OIL LEVEL CHECK
1.
Move roller until level check plug (1) is located at 12
o'clock position and fill plug (2) is located at 3
o'clock position.
TOOLBOX
2.
Turn engine off (WP 0005 00).
3.
Remove 1/2 in. drive ratchet, 6 in. extension, adapter
and 5/16 in. hex bit from toolbox.
4.
Attach 1/2 in. drive ratchet, adapter and 5/16 in. hex
bit to 6 in. extension.
5.
Remove oil level check plug (1) at 12 o'clock posi-
tion, from gearbox (3) through access hole.
6.
Start engine (WP 0005 00).
7.
Move roller to position opening for oil level check
plug (1) at 9 o'clock position.
8.
Turn off engine (WP 0005 00).
1
3
2
9.
Maintain oil level to bottom of level check plug (1)
opening.
10.
If oil level is low, skip steps 10 through 15 and go to
Cleaning and Inspection in this work package.
POSITION FOR
CHECKING SHOWN
401-108
11.
Start engine (WP 0005 00).
12.
Move roller to position opening for oil level check plug (1) at 12 o'clock position.
13.
Turn off engine (WP 0005 00).
14.
Clean and inspect oil level check plug (1).
15.
Install oil level check plug (1) through access hole in gearbox (3).
16.
Stow 1/2 in. drive ratchet, 6 in. extension, and 5/16 in. hex bit in toolbox.
CLEANING AND INSPECTION
NOTE
Notify Field Maintenance to replace plug if damaged.
1.
Clean plug (1) and area around plug openings.
Inspect threads on plug (1) for crossed or peeled condition.
0021 00-2
