TM 5-3895-379-10
VIBRATORY BEARING RESERVOIR CHECK AND SERVICE
THIS WORK PACKAGE COVERS
Check, Fill
INITIAL SETUP
References
Tools and Special Tools
Handle, socket wrench (Item 7, WP 0027 00)
Checks and Services (PMCS) Introduction
Materials/Parts
Equipment Condition
Oil, synthetic (Item 15, WP 0029 00)
Roller parked on level ground (WP 0005 00)
Rag, wiping (Item 16, WP 0029 00)
Vibratory system off (WP 0005 00)
Container, 1 qt. capacity
NOTE
The roller vibratory system consists of two similar vibratory systems located at each end of roller. The
vibratory bearing reservoir oil level gauges are located on left side of front drum and right side of rear
drum.
This work package covers checking and servicing of one vibrating bearing reservoir. Both vibratory
bearing reservoirs are checked and serviced in the same way.
CHECK
1.
Start engine (WP 0005 00).
2.
Move roller until bar (1) is at bottom of drum (2).
3.
Turn off engine (WP 0005 00).
4.
Set parking brake (WP 0005 00).
5.
Check oil level gauge (3). Oil level should fill half of viewing area of oil level gauge.
6.
Fill vibratory bearing reservoir when required. Refer to Fill in this work package.
3
2
1
401-106
