TM 5-3895-383-24
Disassemble Axle 3278-015
Tools Needed
A
B
C
D
E
5P-0982
Repair Stand
1
5P-0979
Adapter Tube
1
FT-1870
Adapter Assembly
1
8B-7551
Bearing Puller Attach
1
1
5P-4170
Step Plate
1
8B-7548
Push-Puller
1
1
5P-9736
Link Bracket
2
8B-7555
Adapter
2
9S-9154
Step Plate
1
8B-7550
Leg
2
8T-3111
Ring Gear Installer
1
Tools Needed
F
G
8B-7548
Push-Puller
1
1
8B-7550
Leg
2
5P-4167
Adapter
1
8H-0663
Bearing Puller attachment
1
1
Start By:
a.
remove axle
NOTE:
The procedure that follows show an axle with
parking brakes. The standard CS-533D, CP-533D,
CS-563D and CP-563D are not equipped with
parking brakes, but optional parking brakes may
be added. The CS-573 and CS-583D are equipped
with parking brakes. Use the necessary steps to
perform the disassembly and assembly for each
particular axle.
1.
Drain the oil from the axle housings.
Typical Example
2.
Use wooden blocks to support the center of the axle as
shown.
Typical Example
3.
Disconnect hose assembly (3) from brake actuator (4).
4.
Remove two nuts and bolts (1). Remove the two nuts
and clamp (2).
Typical Example
Plug (5) is under spring pressure and could cause
personal injury. Remove plug (5) carefully.
5.
Remove the fitting and plug (5) from the brake actuator.
Remove the O-ring seal from the plug. Check the
O-ring seal for wear or damage and replace if
necessary.
14-65
