TM 5-3895-382-24
Rear Reduction Case Assembly
(CS-433C & CP-433C)
Remove And Install Rear Reduction Case Assembly
(CS-433C & CP-433C) 3260 & 3265-010
Start By
a.
remove axle (CS-433C & CP-433C)
1.
Remove axle propel motor (1) from the reduction case
assembly.
2.
Put an alignment mark across the reduction case and
the carrier for assembly purposes.
3.
Remove the drain plug from the rear reduction case
assembly, and drain the oil. The capacity of the rear
reduction case assembly is .95 liters (.250 U.S. gal).
4.
Remove two dowels (2) from the reduction case with a
hammer and a punch.
5.
Remove fifteen bolts (3), the washers and the nuts that
hold reduction case cover (4) in position. Remove the
cover.
6.
Remove snap ring (5) from the reduction case cover,
and discard it. Use new parts for replacement.
7.
Bend lock washer (6) off of outer nut (7). Remove the
outer nut and lock washer.
8.
Remove four bolts (8) and input shaft cap (9) from the
reduction case.
16-105
