TM 5-3895-382-24
Blade
Remove & Install Blade 6151-010
1.
Park the machine on a solid, level surface. Lower the
blade (1).
2.
Remove nut and bolt (2).
3.
Attach a hoist. Remove two nuts and two bolts (3) from
both sides of the machine. Drive out bushings.
4.
Using a hoist, lift the blade away from the machine. The
weight of the blade is approximately 380 kg (840 lb).
NOTE:
For installation of the blade, reverse the removal
steps.
Blade Cylinder
Remove & Install Blade Cylinder
5102-010
At operating temperature, the hydraulic oil tank is hot and
under pressure. Hot oil can cause burns. Remove the fill
cap on the hydraulic oil tank only when the engine is
stopped, and the fill cap is cool enough to touch with your
bare hand.
1.
Release
the
pressure
in
the
hydraulic
system
(page 16-11).
2.
Disconnect hose assembles (1) from blade cylinder (2).
Cap and plug immediately.
3.
Remove nut and bolt (3). Repeat for the opposite end
of the cylinder. Remove the cylinder.
NOTE:
For installation of the blade cylinder, reverse the
removal steps.
NOTE:
After installing the blade cylinder, fill the
hydraulic oil tank to the correct level. See the
Operation and Maintenance Manual for the correct
filling procedures.
16-107
