TM 5-3895-382-24
Disassemble & Assemble Blade
Cylinder 5102-017
Start By:
a.
remove blade cylinder.
1.
Remove two bolts (13), and slide cover (14) and rod
assembly (9) partially out of cylinder assembly (16).
2.
Push head (5) into the cylinder assembly and remove
lockwire ring (8).
3.
Remove head (5) and rod assembly (9) from cylinder
assembly (16).
4.
Remove nut (1), piston (2) and head (5) from rod
assembly (9). Remove O-ring seal (15) from the rod
assembly. Check the O-ring seal for damage or wear
and replace if necessary. During assembly, tighten nut
(1) to a torque of 309 Nom (227 lb-ft).
5.
Remove wear ring (4) and O-ring seal (3) from piston
(2). Check the wear ring and O-ring seal for damage or
wear and replace if necessary.
6.
Remove O-ring seal (6) and back-up ring (7) from the
outside of head (5). Remove lip-type seal (10), O-ring
seal (12) and back-up ring (11) from inside head (5).
Check the back-up rings, O-ring seals and lip-type seal
for damage or wear and replace if necessary.
NOTE:
During assembly of the blade cylinder, put a thin
coat of clean oil on the O-ring seals, back-up
rings and lip-type seal.
NOTE:
For assembly of the blade cylinder, reverse the
disassembly steps.
End By:
a.
Install blade cylinder.
16-108
