TM 5-3895-382-24
Disassemble & Assemble Leveling Blade
Control Valve 5051-017
Start By
a.
remove leveling blade control valve
1.
Thoroughly clean the outside of the leveling blade
control
valve
prior
to
disassembly
to
prevent
contamination of the valve.
2.
Remove all fittings and the O-ring seals from the valve
body. Check O-ring seals for wear or damage. Replace
as required.
3.
Remove two screws (1), retainer plate (2), retainer (21),
and seal (20). Remove spool assembly (19).
4.
Remove relief valve (3). Check O-rings (4) for damage
or wear. Replace as required.
5.
Remove plug (5), O-ring (6), spring (7), and poppet (8).
Check O-ring (6) for damage or wear. Replace as
required.
6.
Remove four screws (12), end cap (11), detent
assembly (13), washer (14), spring (10), collar (15),
spacer (9), spacer (16), retainer (17), and seal (18).
7.
Be sure all internal parts of the leveling blade control
valve are clean. Coat all parts with clean hydraulic oil.
NOTE:
For assembly of the leveling blade control valve.
reverse the disassembly step.
8.
After installing the leveling blade control valve, adjust
the "Relief valve setting". See the "Testing and
Adjusting Manual".
End By:
a.
install leveling blade control valve
16-110
