TM 5-3895-382-24
Disassemble Drum Assembly
6605-015
Tools Needed
A
B
C
6V-2157
Line Bracket
2
FT-2434
Shaft Support Assembly
1
FT-2433
Bearing Removal Block
1
Start By:
a.
remove drum gear reducer
(CS-433C & CP-433C)
b.
remove drum support housing
(CP-433C & CS-433C R.H. Side)
1.
Drain the oil from the drum assembly into a suitable
container. The capacity of the drum assembly is
51 liters (13.5 U.S. gal).
Right (Vibratory) Side of Drum Assembly
2.
Remove retaining ring (1), and remove the five rubber
mounts and washer from the weight shaft.
3.
Attach a suitable lifting bracket and Tooling (A) to right
bearing housing (2) as shown. The weight of the
bearing housing is 110 kg (242 lb).
4.
Use a suitable pry bar (4) and wooden block to support
weight shaft (5).
5.
Remove eight nuts (3), and remove right bearing
housing (2) from the drum assembly. Move the right
bearing housing away from the drum assembly, and
position wooden blocks (6) under weight shaft (5) as
shown.
6.
Lower the weight shaft onto wooden blocks (6), and
remove pry bar (4) and right bearing housing (2).
16-42
