TM 5-3895-382-24
3.
Position retainer (11) on the left and right bearing
housings. Apply 9S-3263 Thread Lock on the threads
of bolts (10). Install four bolts (10) that fasten the
retainer to each of the bearing housings. Tighten the
bolts to a torque of 48 ± 10 N· m (35 ± 7 lb-ft).
4.
Install O-ring seal (9) on each of the bearing housings.
NOTE:
Before installing the bearing housings, make sure
the oil reservoirs have been thoroughly steam
cleaned and tack cloth used during the final
cleaning.
5.
Use a hoist, suitable lifting bracket and Tooling (A) to
position left bearing housing (8) on the drum assembly,
and install eight nuts (7).
6.
Apply 6V-4876 Molycoat Paste Lubricant on the
contact surfaces of weight shaft (5) and the bearing
inside the left bearing housing.
7.
Use a lifting strap and hoist to support Tool (B). Using
one person to hold the end of Tool (B), install weight
shaft (5) in the left bearing housing. Make sure the
correct end of weight shaft (5) is installed in the left
bearing housing. If necessary, use another person to
push weight shaft (5) into the left bearing housing as
shown.
8.
Position wooden blocks under weight shaft (5) as
shown. Remove Tool (B) from the weight shaft.
16-45
