TM 5-3895-382-24
Disassemble & Assemble Drum
Support Housing (CP-433C &
CS-433C R.H. Side) 5656-017
Tools Needed
A
B
9U-6237
Spanner Wench
1
1P-0510
Driver Group
1
Start By:
a.
remove drum support housing
1.
Make sure the outside of the drum support housing is
clean and free of dirt and debris.
2.
Put alignment marks on the housing and cover to aid in
the assembly steps.
3.
Install the drum support housing on a suitable stand or
move to a clean flat area for disassembly. The weight
of the drum support housing is 73 kg (160 lb).
4.
Remove twelve bolts (1).
NOTE:
Every third bolt in the pattern has a lock washer
and is slightly longer than the other bolts. Mark
or identify for later installation.
5.
Remove cover (2).
6.
For the drum support housing, on the right hand side
(CS-431C, CP-433C & CS-433C), remove O-ring (3).
Check the O-ring seal for wear or damage. Replace if
necessary. For the drum support housing on the left
hand side (CS-431C only) uses 9T-9014 Silicone
Sealant to seal the cover to the housing.
7.
Bend tab on washer (5) away from corresponding slot in
nut (4).
8.
Use Tool (A) to remove retaining nut (4).
NOTE:
During assembly, 9S-6232 Thread Lock was used
on nut (4). To remove the nut, it may be
necessary to slightly heat nut (4).
16-39
