TM 5-3895-382-24
10.
Remove the two bolts and plate (9).
11.
Remove the two bolts and clamp (10). Move the three
hose assemblies and electrical harness out of the way.
12.
Disconnect five hose assemblies (11) from drum propel
motor (12). Plug and cap immediately.
13.
Remove the two bolts and plate (13).
14.
Remove the two bolts and clamp (14). Move the five
hose assemblies out of the way.
15.
Attach a suitable hoist to both sides of drum assembly
(17) as shown. Raise the drum assembly approximately
12.7 mm (0.50 in). Install a suitable stand (15) under
each side of yoke (16) as shown.
16.
Use the suitable hoist to support the drum assembly.
NOTE:
When removing the drum assembly, note the
thickness and number of the shims on each side
of the yoke. When installing the drum assembly,
install the shims in their original location.
17.
Remove six bolts (18) that fasten drum assembly (17) to
the left (propel) side of yoke (16). Remove any shims
that may be between the mounting plate and the yoke.
16-24
