TM 5-3895-382-24
Drum Assembly
Remove & Install Drum Assembly
6605-010
Star By:
a.
connect steering pivot lock
1.
Remove the bumper and front scraper. Refer to the
topic "Remove & Install Bumper & Front Scraper" in this
module.
At operating temperature, the hydraulic oil tank is hot and
under pressure. Hot oil can cause burns. Remove the fill
cap on the hydraulic oil tank only when the engine is
stopped, and the fill cap is cool enough to touch with your
bare hand.
2.
Release the pressure in the hydraulic system (page 16-
11).
3.
Drain the hydraulic oil from the hydraulic oil tank into a
suitable container. The capacity of the hydraulic oil tank
is 72 liter (19 U.S. gal).
4.
To prevent movement of the machine, put wooden
blocks in front of and behind each rear wheel.
5.
Disconnect hose assembles (1), (3) and (4) from
vibratory motor (2). Cap and plug immediately.
6.
Remove clamp (5) that fastens hose assembly (4) to the
support.
7.
Remove the bolt and clamp that fastens wiring harness
(6) to cover (7).
8.
Remove the bolt and cover (7) from the drum support
housing.
9.
Move the cover back, and put identification marks on
the two wires for vibratory sensor (8). Disconnect the
two wires from the vibratory sensor.
16-23
