TM 5-3895-382-24
Disassemble & Assemble Steering
Pump 4306-017
Start By:
a.
remove steering pump
1.
Remove nut (22), and remove gear (20) and woodruff
key (21) from drive gear (11). When assembling the
steering pump tighten nut (22) to a torque of
50 to 54 N· m (37 to 40 lb-ft).
2.
Remove four bolts (14), and remove end cap (6) from
housing (10).
3.
Remove plug (1), spring (4) and priority valve (5) from
end cap (6). Remove O-ring seal (3) from plug (1).
Check the O-ring seal for damage or wear and replace if
necessary.
4.
Remove flange (15) from housing (10) and drive gear
(11).
5.
Remove retaining ring (17), and remove lip-type seal
(16) from flange (15). Check the lip-type seal for
damage or wear and replace if necessary.
6.
Remove backup seals (8) and seals (18) from both
sides of housing (10).
7.
Remove drive gear (11), driven gear (19) and bushings
(9) and (12) from housing (10).
8.
Remove O-ring seals (7) and (13) from each side of the
housing. Check the O-ring seals for damage or wear
and replace if necessary.
9.
If necessary, remove the two dowels from each side of
housing (10).
NOTE: For assembly of the steering pump, reverse the
disassembly steps.
End By:
a.
install steering pump
16-14
