TM 5-3895-382-24
Disassemble & Assemble Steering
Cylinder 4303-017
Start By:
a.
remove steering cylinder
1.
Remove two bolts (11), and slide cover (14) and rod
assembly (10) partially out of cylinder assembly (12).
2.
Push head (5) into the cylinder assembly and remove
lockwire ring (8).
3.
Remove head (5) and rod assembly (10) from cylinder
assembly (12).
4.
Remove nut (1), piston (2) and head (5) from rod
assembly (10). Remove O-ring seal (13) from the rod
assembly. Check the O-ring seal for damage or wear
and replace if necessary. During assembly, tighten nut
(1) to a torque of 820 ± 28 N· m (590 ± 20 lb-ft).
5.
Remove wear ring (3) and O-ring seal (4) from piston
(2). Check the wear ring and O-ring seal for damage or
wear and replace if necessary.
6.
Remove O-ring seal (6) and back-up ring (7) from the
outside of head (5). Remove lip-type seal (9), and seal
(15) from inside head (5). Check the back-up rings,
O-ring seals and lip-type seal for damage or wear and
replace if necessary.
NOTE: During assembly of the steering cylinder, put a
thin coat of clean oil on the O-ring seals, back-up
rings and lip-type seal.
NOTE: For assembly of the steering cylinder, reverse the
disassembly steps.
End By:
a.
install steering cylinder
16-12
