TM 5-3895-382-24
Illustration 102
10.
Lubricate oil seal (3) with clean engine oil. Install oil
seal (3) with the flat surface toward the bearing.
Press oil seal (3) into the body with a suitable adapter
until the rear of the seal is level with the end of the
pump.
11.
Continue to apply force and hold oil seal (3) in
position for ten seconds. This ensures that the seal
will remain in place.
12.
Press gear (4) onto shaft (6) to a depth of 1.60 ± 1.00
mm (.015 ± .005 inch).
NOTE:
Apply 4C-9507 Retaining Compound to gear (4) if
the original gear is used. Remove excess
compound after assembly.
Illustration 103
13.
Install a new gasket and cover (2) on the pump body.
14.
Install six bolts (1). Tighten the bolts to a torque of 9
N m (80 lb-in).
End By:
a.
Install the water pump. Refer to Disassembly and
Assembly, “Water Pump - Install"
Water Pump - Install
SMCS Code: 1361-012
Installation Procedure
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
1.
Inspect the condition of the gasket. Replace the
gaskets, if necessary.
Illustration 104
Typical example
2.
Install the gasket and water pump (3).
3.
Install eight bolts (1) and two nuts (2).
NOTE:
Fill the cooling system with coolant to the correct
level. Refer to the Operation and Maintenance
Manual for the correct procedure.
Water Temperature Regulator - Remove and Install
SMCS Code: 1355-010
Removal Procedure
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
7-44
