TM 5-3895-382-24
NOTICE
Care must be taken to ensure that fluids are contained
during performance of inspection, maintenance, testing,
adjusting and repair of the product. Be prepared to collect
the fluid with suitable containers before opening any
compartment or disassembling any component containing
fluids.
Refer to Special Publication, NENG2500, "Caterpillar Tools
and Shop Products Guide" for tools and supplies suitable
to collect and contain fluids on Caterpillar products.
Dispose of all fluids according to local regulations and
mandates.
1.
Drain the coolant from the cooling system into a suitable
container for storage or disposal.
Illustration 94
Typical example
2.
Remove eight bolts (1) and two nuts (2).
3.
Tap water pump (3) with a soft hammer in order to
loosen water pump (3).
4.
Remove water pump (3) and the gasket.
Water Pump - Disassemble (Type 1 Engines and
9RM Engines)
SMCS Code: 1361-015
Disassembly Procedure
Table 15
Required Tools
Tool
Part
Number
Part Description
Qty
6V-3009
Crossbar
1
5H-9976
Screw
1
9S-9152
Bearing Pull
1
A
7X-0290
Bolt
2
Start By:
a.
Remove the water pump. Refer to Disassembly and
Assembly "Water Pump - Remove".
NOTE:
For a complete description of Type 1 and Type 2
engines, refer to the Disassembly and Assembly,
"Engine Design" topic.
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
NOTICE
Care must be taken to ensure that fluids are contained
during performance of inspection, maintenance, testing,
adjusting and repair of the product. Be prepared to collect
the fluid with suitable containers before opening any
compartment or disassembling any component containing
fluids.
Refer to Special Publication, NENG2500, "Caterpillar Tools
and Shop Products Guide" for tools and supplies suitable
to collect and contain fluids on Caterpillar products.
Dispose of all fluids according to local regulations and
mandates.
7-41
