TM 5-3895-382-24
Illustration 91
2.
Fill engine oil pump (7) with clean engine oil. Install
engine oil pump (7) on the engine.
3.
Install three bolts (6). Tighten the bolts to a torque of 22
N m (16 Ib-ft).
Illustration 92
4.
Install idler gear (5).
5.
Use Tool (A) to install retaining ring (4).
NOTE:
After you install the engine oil pump and the idler
gear, ensure that there is a minimum of 0.08 mm
(.003 inch) backlash between the gear on the
engine oil pump and the idler gear.
6.
Install the engine oil relief valve. Refer to Disassembly
and Assembly, "Engine Oil Relief Valve - Install".
Illustration 93
7.
Install the strainer, suction pipe (3), and the gasket.
8.
Install bolt (2). Tighten the bolt to a torque of 22 N m
(16 lb-ft).
9.
Install two bolts (1). Tighten the bolts to a torque of 22
N m (16 Ib-ft).
End By:
a.
Install the front housing. Refer to Disassembly and
Assembly, "Housing (Front) - Install".
Water Pump - Remove
SMCS Code: 1361-011
Removal Procedure
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
7-40
