TM 5-3895-382-24
4.
Remove four bolts (1). Timing gear (2) should be free
from the fuel injection pump shaft.
Illustration 39
Typical example
5.
Remove three nuts (9) and fuel Injection pump (10) from
the engine.
Illustration 40
Typical example
6.
Remove O-ring seal (11) from fuel injection pump (10).
Fuel Injection Pump- Install (Type 2 Engines and 7BJ
Engines)
SMCS Code: 1251-012
Installation Procedure
Table 4
Required Tools
Tool
Part
Number
Part Description
Qty
150-3992
Timing Pin(1)
1
A
150-3993
Timing Pin(2)
1
(1)
The timing pin is required to install Bosch fuel injection
pumps.
(2)
Timing pin is required to install Lucas and Stanadyne
fuel injection pumps.
NOTE:
For a complete description of Type 1 and Type 2
Engines, refer to the Disassembly and Assembly,
"Engine Design" topic.
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
Illustration 41
1.
Check the condition of O-ring seal (1) from fuel injection
pump (2). If the seal is worn or damaged, use a new
par for replacement.
2.
Lightly lubricate O-ring seal (1) with clean engine oil.
Install O-ring seal (1) on fuel injection pump (2).
7-19
