TM 5-3895-382-24
2.
Remove cover (2).
Illustration 30
3.
Remove nut (3) and the lockwasher.
Illustration 31
4.
Use Tool (B) to rotate the crankshaft until keyway (X) is
at 30 degrees from the vertical centerline.
Illustration 32
5.
Install Tool (C).
6.
Disengage the gear from the fuel injection pump.
Illustration 33
7.
Disconnect hose (7) from the fuel injection pump.
8.
Remove three nuts (6) that hold fuel injection pump (5)
in position.
9.
Remove fuel injection pump (5) and the gasket.
NOTE:
Ensure that you do not lose the key when the fuel
injection pump is removed. Also notice the
position of marks (4) in order to ensure proper
alignment of fuel Injection pump (5) during
installation.
Fuel Injection Pump - Install (Type 1 Engines and
9RM Engines)
SMCS Code: 1251-012
Installation Procedure
Table 2
Required Tools
Tool
Part
Number
Part Description
Qty
A
173-9774
Bolt Remover (1)
1
(1)
The bolt remover is required in order to install the
tamper proof bolts on the access cover for the fuel
injection pump.
NOTE:
For a complete description of Type 1 and Type 2
Engines, refer to the Disassembly and Assembly,
"Engine Design" topic.
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
7-16
