TM 5-3895-382-24
NOTE:
Do not rotate the fuel injection nozzle after
installation. The seal which is made by the anti-
seize compound may break. A broken seal may
allow leakage pat the seat of the fuel injection
nozzle.
Illustration 28
7.
Put tube assembly (2) in position on the fuel injection
nozzles.
8.
Install bolts (1) that hold tube assembly (2) in position.
End By:
a.
Install the fuel injection lines. Refer to Disassembly
and Assembly, "Fuel Injection Lines - Remove and
Install".
Fuel Injection Pump - Remove
(Type 1 Engines and 9RM
Engines)
SMCS Code: 1251-011
Removal Procedure
Table 1
Required Tools
Part
Tool
Number
Part Description
Qty
A
173-9774
Bolt Remove(1)
1
B
9U-6198
Crankshaft Turning Tool
1
8S-2264
Puller Group
1
C
8S-4712
Bolt
2
(1)
The bolt remover is required in order to remove the tamper Proof
bolts on the ass cover r the fuel pump.
Start By:
a.
Remove the water pump. Refer to Disassembly and
Assembly, "Water Pump - Remove".
b.
Remove the fuel injection lines. Refer to Disassembly
and Assembly, "Fuel Injection Lines - Remove and
Install".
NOTE:
For a complete description of Type 1 and Type 2
engines, refer to the Disassembly and Assembly,
"Engine Design" topic.
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
NOTICE
Care must be taken to ensure that fluids are contained
during performance of inspection, maintenance, testing,
adjusting and repair of the product. Be prepared to collect
the fluid with suitable containers before opening any
compartment or disassembling any component containing
fluids.
Refer to Special Publication, NENG2500, "Caterpillar Tools
and Shop Products Guide" for tools and supplies suitable
to collect and contain fluids on Caterpillar products.
Dispose of all fluids according to local regulations and
mandates.
Illustration 29
NOTE:
Some engines may have four tamper proof bolts
(1). Use Tool (A) in order to remove the tamper
proof bolts.
7-15
