TM 5-3895-379-23
MAIN WIRING HARNESS REPLACEMENT (CB534C)
THIS WORK PACKAGE COVERS
Removal, Installation
INITIAL SETUP
Tools and Special Tools
References
Tool kit, general mechanic's (Item 36, WP 0220 00)
Instructions
Shop equipment, general purpose (Item 30, WP
TM 5-3895-379-23P, Figures 62 and 63
Equipment Condition
Engine off (TM 5-3895-379-10)
Materials/Parts
Operator platform assembly raised (WP 0128 00)
Strap, tiedown (Item 36, WP 0219 00)
Battery disconnect switch in OFF position (TM 5-
3895-379-10)
Tag, marker (Item 37, WP 0219 00)
NOTE
Refer to Repair Parts and Special Tools Lists (TM 5-3895-379-23P) for identification.
Main wiring harness can be repaired without being removed from roller. Refer to WP 0213 00 for repair
instructions as needed.
REMOVAL
NOTE
Tag and mark all wires prior to removal to aid in installation.
Cut tiedown straps as needed for removal. Discard tiedown straps.
Note position and routing of main wiring harness as it is disconnected and removed to aid in installa-
tion.
1.
Disconnect main harness wire terminals from drum offset switch connector (TM 5-3895-379-23P, figure 63, item A).
2.
Disconnect main harness wire terminals from cutter switch connector (TM 5-3895-379-23P, figure 63, item B).
3.
Disconnect main harness wire terminals from drum select switch connector (TM 5-3895-379-23P, figure 63, item C).
4.
Disconnect main harness wire terminals from dual amp switch connector (TM 5-3895-379-23P, figure 63, item D).
5.
Disconnect main harness connector from work light control switch connector (WP 0075 00).
6.
Disconnect main harness wire terminals from water spray switch connector (WP 0070 00).
7.
Disconnect main harness connector from auto man switch connector (TM 5-3895-379-23P, figure 63, item G).
