TM 5-3895-379-23
MAIN WIRING HARNESS REPLACEMENT (CB534B)
THIS WORK PACKAGE COVERS
Removal, Installation
INITIAL SETUP
Tools and Special Tools
References
Instructions
Shop equipment, general purpose (Item 30, WP
TM 5-3895-379-23P, Figure 63
Equipment Condition
Engine off (TM 5-3895-379-10)
Materials/Parts
Battery disconnect switch in OFF position (TM 5-
3895-379-10)
NOTE
Refer to Repair Parts and Special Tools Lists (TM 5-3895-379-23P) for identification.
Main wiring harness can be repaired without being removed from roller. Refer to WP 0213 00 for
repair instructions as needed.
REMOVAL
NOTE
Tag and mark all wires prior to removal to aid in installation.
Cut tiedown straps as needed for removal. Discard tiedown straps.
Note position and routing of main wiring harness as it is disconnected and removed to aid in installa-
tion.
1.
Disconnect main harness wire terminals from throttle control timer connector (WP 0045 00).
2.
Disconnect main harness connector from main relay connector (WP 0067 00).
3.
Disconnect main harness connector from light circuit breaker connector (WP 0086 00).
4.
Disconnect main harness connector from intermittent spray timer connector (WP 0076 00).
5.
Disconnect main harness connector from rear intermittent relay connector (TM 5-3895-379-23P, figure 63, item
G).
6.
Disconnect main harness connector from front intermittent relay connector (TM 5-3895-379-23P, figure 63, item
H).