TM 5-3895-379-23
CRANKSHAFT REAR OIL REPLACEMENT - CONTINUED
0166 00
INSTALLATION - CONTINUED
2.
Position seal installer (9) onto crankshaft flange.
3.
Install new gasket (5) to cylinder block dowels (7).
4.
Install housing (4) and new oil seal (5) as an assembly on the two cylinder block dowels (7). Remove seal installer (9).
4
4
5
6
401-2083
7
401-2083
5
9
401-1689
NOTE
If installing M8 bolts, tighten two bolts to 160 lb-in (18 Nm). If installing M6 bolts, tighten two bolts to 116
lb-in (13 Nm).
5.
Install twelve bolts (1), two washers (3) and socket head bolts (2) in housing (4). Tighten eight bolts to 16 lb-ft (22
Nm).
6.
Install flywheel housing (WP 0169 00).
7.
Install flywheel (WP 0168 00).
END OF WORK PACKAGE
0166 00-3/(0166 00-4 Blank)
