TM 5-3895-379-23
WATER TANK REPLACEMENT
THIS WORK PACKAGE COVERS
Removal, Installation
INITIAL SETUP
Tools and Special Tools
Equipment Condition
Tool kit, general mechanic's (Item 36, WP 0220
Engine off (TM 5-3895-379-10)
Drums chocked (TM 5-3895-379-10)
Shop equipment, common no. 1 (Item 28, WP
Water tank drained (TM 5-3895-379-10)
Materials/Parts
Water level gauge removed (WP 0156 00)
Compound, sealing (Item 13, WP 0219 00)
Locknut
Water tank strainer assembly removed (WP 0153
References
TM 5-3895-379-23P, Figure 134
Water spray pipe assembly removed (WP 0152
Personnel Required
Water spray check valve removed (WP 0148 00)
Two
REMOVAL
WARNING
Use caution when removing cover from bumper assembly. Failure to follow this warning may cause injury.
NOTE
Cover weighs 12 lb (5.44 kg).
Front and rear water tanks are replaced the same way. Front water tank is shown.
If removing water tank for wiring harness or front or rear support replacement, perform only steps 1
and 2 and steps 5 and 6.
1.
Remove four screws (1), washers (2) and cover (3) from bumper assembly (4).
4
3
2
1
401-743
