TM 5-3895-379-23
WATER SPRAY CHECK VALVE REPLACEMENT
THIS WORK PACKAGE COVERS
Removal, Cleaning and Inspection, Installation
INITIAL SETUP
Materials/Parts - Continued
Tools and Special Tools
Wood block, approximately 6 in. (152 mm) tall, 6
Tool kit, general mechanic's (Item 36, WP 0220 00)
in. (152 mm) and 12 in. (305 mm) long
Shop equipment, common no. 1 (Item 28, WP 0220
References
TM 5-3895-379-23P, Figure 134
Materials/Parts
Brush, cleaning (Item 6, WP 0219 00)
Equipment Condition
Cloth, cleaning (Item 10, WP 0219 00)
Engine off (TM 5-3895-379-10)
Compound, sealing (Item 12, WP 0219 00)
Drums chocked (TM 5-3895-379-10)
Detergent (Item 14, WP 0219 00)
Water spray system drained (or low) (TM 5-3895-
379-10)
Locknut (2)
NOTE
Front and rear front water spray check valves are replaced the same way. Front water spray check valve is
shown.
REMOVAL
1.
Remove two locknuts (1), washers (2) and straps (3) from bumper assembly (4). Discard locknuts.
2.
Lift water tank (5) and place wood block between tank and drum (6).
5
WOOD
BLOCK
3
2
4
1
6
401-755
