TM 5-3895-379-23
WATER SPRAY PIPE ASSEMBLY MAINTENANCE - CONTINUED
0152 00
INSTALLATION - CONTINUED
3.
Lift water spray tank (5) and remove wood block.
5
4.
Lower water spray tank (5) on bumper assembly (4).
5.
Install two straps (3) in bumper assembly (4) with two
washers (2) and new locknuts (1). Tighten locknuts
until strap tension is snug.
WOOD
3
BLOCK
6.
Fill water spray system and check for leaks (TM 5-
3895-379-10).
2
4
1
6
401-7
ADJUSTMENT
NOTE
Water spray pipes are correctly adjusted when water spray covers 100% of width of drum surface. There are
two methods of adjustment.
1.
Method A (perform every time spray pipe is removed).
a.
Start engine and operate water spray system (TM 5-3895-379-10).
b.
While screws (11) are not tightened, turn spray pipe assembly (15) until water spray makes best contact with drum
surface.
c.
Tighten screws (11).
d.
Turn off water spray system and engine (TM 5-3895-379-10).
WATER
SPRAY
PIPE
11
15
DRUM
SURFACE
401-769
0152 00-6
