TM 5-3895-379-23
WATER TANK REPLACEMENT - CONTINUED
0154 00
INSTALLATION - CONTINUED
4.
Position straps (15) in front of bumper assembly (4).
14
WARNING
Use caution when handling heavy parts. Pro-
vide adequate support and use assistance dur-
4
ing procedure. Ensure that any lifting device
used is in good condition and of suitable load
capacity. Keep clear of heavy parts supported
only by lifting device. Failure to follow this
warning may cause injury or death.
NOTE
Water tank weighs 91 lb (41 kg).
15
401-774
5.
With assistance, install water tank (14) on bumper
assembly (4).
6.
Apply sealing compound to threads of nipple (13)
and install nipple (13) in water tank (14).
7.
Install cap assembly (10) on bumper bracket (12)
with bolt (11), two washers (9) and new locknut (8).
Tighten locknut to 7-11 lb-ft (9-15 Nm).
5
6
7
14
8.
Install cap assembly (10) on nipple (13) by turning
tee-handle fully right until cap assembly is snug in
nipple.
13
12
9.
Position tube (6) on elbow (7) and tighten fitting (5).
10
11
9
9
8
401-773
0154 00-4
