TM 5-3895-379-23
HYDRAULIC OIL FILTER REPLACEMENT - CONTINUED
CLEANING AND INSPECTION
1.
Clean filter assembly (1) base and ensure that all old gasket material is removed.
NOTE
Excessive amounts of debris in filter can be an indication of internal wear and possible hydraulic system
component failure. If large amounts of debris are found, notify Direct Support Maintenance.
2.
Inspect element (3) for metal or other debris. Report
any excessive debris found in element to supervisor.
INSTALL
1
3
REMOVE
2
4
401-2072
INSTALLATION
CAUTION
Do not overtighten filter on filter base. Failure to follow this caution may cause damage to filter.
1.
Apply a light coat of lubricating oil on filter gasket (4).
2.
Install filter (2) on filter base (1). Tighten filter 3/4 of a turn after filter makes contact with filter base.
3.
Close right-side door assembly (TM 5-3895-379-10).
4.
5.
Start engine (TM 5-3895-379-10) and check for leaks.
END OF WORK PACKAGE
0143 00-2