TM 5-3895-379-23
FRONT AND REAR SUPPORTS (BUMPERS) REPLACEMENT - CONTINUED
0122 00
INSTALLATION
WARNING
Use caution when handling heavy parts. Provide adequate support and use assistance during procedure.
Ensure that any lifting device used is in good condition and of suitable load capacity. Keep clear of heavy
parts supported only by lifting device. Failure to follow this warning may cause injury or death.
NOTE
Bumper weighs 625 lb (283 kg).
1.
Attach a lifting device to bumper assembly (2).
2.
Operate lifting device while assistant guides the bumper assembly (2) into position on yoke assembly (5).
3.
Install six screws (3) and washers (4) in yoke assembly (5) and bumper assembly (2). Tighten screws to 295-385 lb-ft
(400-522 Nm).
NOTE
Replace cable ties as required.
4.
Pull wiring harness (1) through hole in backside of bumper assembly (2) and position for component installation.
5.
Install front and/or rear scraper bar (WP 0160 00).
6.
Install water lines (WP 0159 00).
7.
Install work light assemblies (WP 0091 00).
8.
Install water spray pump (WP 0155 00).
9.
Install water spray strainer assembly (WP 0153 00).
10.
Install warning horn assembly (WP 0099 00).
Install water tank assembly (WP 0154 00).
11.
12.
Install vehicle classification sign kit (WP 0139 00).
13.
Start engine (TM 5-3895-379-10).
14.
Remove chocks (TM 5-3895-379-10).
END OF WORK PACKAGE
0122 00-3/(0122 00-4 Blank)
