TM 5-3895-379-23
FRONT AND REAR SUPPORTS (BUMPERS) REPLACEMENT - CONTINUED
0122 00
REMOVAL
NOTE
Remove cable ties as necessary.
1.
Pull wiring harness (1) through hole in backside of bumper assembly (2) and position in a safe area.
WARNING
Use caution when handling heavy parts. Provide adequate support and use assistance during procedure.
Ensure that any lifting device used is in good condition and of suitable load capacity. Keep clear of heavy
parts supported only by lifting device. Failure to follow this warning may cause injury or death.
NOTE
1
Bumper assembly weighs 625 lb (283
2
4
kg).
1.
Attach a lifting device to bumper assembly (2).
2.
Remove six screws (3) and washers (4) from bumper
assembly (2).
3.
Operate lifting device while assistant guides bumper
assembly (2) away from yoke assembly (5).
3
1
5
LIFTING
DEVICE
2
FRONT SIDE SHOWN
401-670
REAR SIDE SIMILAR
0122 00-2
