TM 5-3895-379-23
HYDRAULIC STEERING CYLINDERS REPLACEMENT - CONTINUED
0121 00
REMOVAL - CONTINUED
4.
Remove two screws (7), washers (8) and spacers (9) from frame assembly (10) and yoke assembly (11).
NOTE
The number of spacers used may vary from one roller to the next.
5.
Remove two pin assemblies (12) and hydraulic steer-
7
7
8
ing cylinder (5) from frame assembly (10) and yoke
assembly (11).
13
8
9
6.
Remove lubrication fitting (13) from frame assembly
9
(10).
12
14
7.
Remove alignment bearing (14) from yoke assembly
(11).
11
12
10
5
401-668
INSTALLATION
1.
Install alignment bearing (14) in yoke assembly (11).
2.
Install lubrication fitting (13) on frame assembly (10).
3.
Position hydraulic steering cylinder (5) on frame assembly (10) and yoke assembly (11).
4.
Install two pin assemblies (12) in frame assembly (10) and yoke assembly (11).
5.
Install spacers (9), washers (8) and screws (7) in frame assembly (10) and yoke assembly (11) to lock two pin assem-
blies (12) in place. Tighten screws to 33-47 lb-ft (45-64 Nm).
6.
Remove caps and install hydraulic lines (3) and (4) on hydraulic steering cylinder fittings (6).
7.
Tighten fittings (1) and (2).
8.
Close right- and left-side door assemblies (TM 5-3895-379-10).
9.
Start engine, operate steering (TM 5-3895-379-10) and check for leaks.
10.
Remove chocks (TM 5-3895-379-10).
END OF WORK PACKAGE
0121 00-3/(0121 00-4 Blank)
