TM 5-3895-379-23
TROUBLESHOOTING PROCEDURES - CONTINUED
0006 00
Table 2. Electrical Troubleshooting Procedures - Continued.
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
Remove all jewelry such as rings, dog tags and bracelets. If jewelry
contacts electrical connection, a direct short may occur resulting in
injury or death, or damage to equipment.
Use caution while working under operator platform assembly. Fall-
ing platform may cause injury or death.
CAUTION
Operating starter for more than 30 seconds at a time can cause
starter damage due to heat buildup. After 30 seconds, starter must be
stopped for 2 minutes to allow starter to cool.
1. Check for power to starter relay. 1. If voltage does drop to zero Vdc,
4.
Starter Continues to Run After
Open left-side door assembly
Engine Start Switch Key Is
go to Step 2.
(TM 5-3895-379-10). Remove
Released.
harness connector from starter 2. If voltage does not drop to zero
Vdc, replace engine start switch
relay switch assembly. Turn
battery disconnect switch to ON
position (TM 5-3895-379-10).
Set multimeter to measure Vdc.
Touch positive (+) probe of
multimeter (wire 306-GN) of
harness
connector.
Touch
negative (-) probe of multimeter
to good ground. Have assistant
turn engine start switch to start
position
until
voltage
is
measurable on multimeter. Have
assistant turn engine start switch
to OFF position (TM 5-3895-
379-10). Voltage should drop to
zero Vdc.
