TM 5-3895-379-23
TROUBLESHOOTING PROCEDURES - CONTINUED
0006 00
Table 2. Electrical Troubleshooting Procedures - Continued.
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
Starter Does Not Turn or Turns Slowly 12. Check for good ground to neutral 1. If multimeter measures infinite
2.
start relay no. 1 coil. Touch
ohms, repair or replace wire 200-
- Continued.
positive (+) probe of multimeter
BK and connectors (WP 0108 00).
to terminal 2 (wire 200-BK) of
2. If multimeter does read zero ohms,
harness connector and negative
go to Step 13.
(-) probe to good ground.
Multimeter should measure zero
ohms.
SCREW
WASHER
PANEL ASSEMBLY
TERMINALS
2
WASHER
SCREW
1
4
3
5
HARNESS
CONNECTOR
RELAY
NEUTRAL START RELAY #1
OPERATOR STATION
401-198
13. Check for power to engine start 1. If 24 to 28 Vdc are not present at
switch. Remove two shoulder
BAT terminal (wire 105-BR), and
screws, washers and vandal guard
KEY START fuse is good, replace
from box assembly. Remove
or repair wiring and connectors to
three screws and washers and lift
KEY START fuse holder (WP
box assembly up from operator
station. Touch positive (+) probe
of multimeter to BAT terminal 2. If 24 to 28 Vdc are present at BAT
terminal, go to Step 14.
(wire 105-BR) of engine start
switch. Touch negative (-) probe
of multimeter to good ground.
0006 00-60
