TM 5-3895-379-23-1
0082
CLEANING
Clean top of cylinder block (Figure 4, Item 1) and bottom of cylinder head (Figure 4, Item 2).
END OF TASK
INSPECTION
1.
Inspect cylinder head (Figure 4, Item 2) for cracks, damage, and warpage. Replace cylinder head if damaged.
2.
Inspect cylinder head bolts for damage, distortion, and reduction in threads. Replace head bolts if damaged.
1
2
M1125SWR
Figure 4.
Cylinder Head Cleaning and Inspection.
END OF TASK
INSTALLATION
NOTE
Note location of dowels on each end of cylinder block. Dowels hold cylinder head gasket
in place while cylinder head is installed.
Be sure to locate "FRONT TOP," stamped on gasket, for correct installation.
Do not use any sealant or gasket compound on cylinder head gasket.
1.
Install new cylinder head gasket (Figure 5, Item 1) to cylinder block (Figure 5, Item 2).
03/15/2011Rel(1.8)root(maintwp)wpno(M00021)
