SECTION 8
FINAL DRIVE AND TRANSFER CASE
d. Remove the lower tapered roller bearing
and the roller bearing from the shaft end.
8-30. DISASSEMBLY OF DIFFERENTIAL.
a. Mark the differential case halves for
reassembly.
b. Cut lock wire and remove bolts from
case.
c. Separate the halves.
NOTE: Remove ring gear only if necessary.
d. Mark gear and case and remove rivets as
shown in figure 8-28. Separate the gear from
the case.
e. If it is necessary to replace the differential
bearings, place the case in a press (see figure
FIGURE 8-26.
8-29) and press the bearing from the journal.
FIGURE 8-29.
FIGURE 8-27.
8-31.
CLEANING.
a. Clean parts having ground and polished
with solvent type cleaners such as emulsion
c l e a n e r s or petroleum solvent excluding
gasoline. Do not clean these parts in a hot
s o l u t i o n tank or with water and alkaline
solution.
b. Rough parts such as differential carrier
casting may be cleaned in hot solution tanks
with mild alkali solutions, providing these
FIGURE 8-28.
parts are not ground or polished.
8-9.