TM 5-3895-346-14
POWER STEERING
STEERING CONTROL REASSEMBLY
Reposition in vise and clamp across the edges of the mounting plate. Check to insure that the spool and
sleeve are flush or slightly below the 14 hole surface of the control housing (refer to Fig. 44).
Clean the upper surface of the housing by wiping with the back of a clean hand or the butt of the thumb. Clean
each of the flat surfaces of the meter sec- tion parts as it is ready for assembly in a similar way (refer to Fig.
45).
Place the plate over this assembly so that the boltholes in the plate align with the tapped holes in the housing
(refer to Fig. 46). Place the meter gear ring on the assembly so that the boltholes align (refer to Fig. 47).
Place the splined end of the drive within the meter-gear star so that the slot at the control end of the drive is in
alignment with the valleys between the meter-gear teeth (refer to Fig. 48).
Figure 43.
Figure 45.
Figure 44.
Figure 46.
589