TM 5-3895-383-24
6.
Remove spring (7) from inside brake actuator (4).
7.
Remove the two nuts from inside the brake actuator.
The two nuts hold the brake actuator on the brake
caliper shaft.
8.
Remove bracket (6) and brake actuator (4) from the left
side axle housing.
9.
Remove the two nuts and bracket (8).
10.
At the bottom of the axle assembly, remove the four
bolts that fasten left side axle housing (9) to the
differential housing.
11.
Position wooden blocks under the right side axle
assembly to support it when the left side axle assembly
is removed. Attach lifting straps and a hoist to left side
axle assembly (9) as shown. Remove remaining seven
bolts (10), and remove left side axle housing (9) from
the differential housing. The weight of the left side axle
housing is 117 kg (260 lb). Remove the O-ring seal
from the left side axle housing. Check the O-ring seal
for wear or damage and replace if necessary.
12.
Use Tooling A to support left side axle assembly as
shown.
14-66
