TM 5-3895-383-24
8. Install stroking piston (53) in cover (49) and install nut
(52).
9. Install the O-ring seal on cover (49). Install the stroking
piston and cover (49) in the housing, and install four
bolts (51).
10. Install limiting screw (50) in cover (49), install the limiting
screw in the other side of the housing, and tighten the
jam nuts on each limiting screw.
11. Position the gasket and control valve (47) on the
housing, and install five screws (48).
12.
Install pins (46) in the housing.
13.
Install bearing races (45) in the housing.
14.
Assemble cradle assembly (37) as follows:
NOTE:
During assembly of the cradle assembly, apply
5P-0960 Multipurpose Grease to bearings (41) and
(43). The grease will hold the bearings in place on
the cradle during assembly.
a.
Install wire (42) and bearing (43) on cradle (38).
b.
Install pin joint (39), slide (40), bearing (41) and wire
(44) on cradle (38).
14-35
