TM 5-3895-383-24
14.
Remove port plate (27) tom the cylinder bock.
15.
Remove O-ring seal (28) from the housing. Check the
O-ring seal for wear or damage and replace if
necessary.
16.
Hold cylinder block (29) on the shaft. Turn the housing
over and separate the housing and shaft from cylinder
block (29) and the pistons.
17.
Mark nine pistons (30) for reassembly and remove
pistons, plate (31) and balljoint (32) from cylinder block
(29).
18.
Use a screwdriver to push against spacer (34).
Compress the spring and remove three pins (33) from
the grooves in the cylinder block.
There is spring force against retaining ring (35). When
retaining ring (35) is removed, the spring force will be
released. To prevent possible personal injury, removal of
the internal components in cylinder block (29) should be
performed in a press in order to retain spring (36) and
spacer (34).
19.
Put cylinder block (29) in a press. Install a suitable
piece of square steel stock against spring (36). Put
slight compression on spring (36) with the press.
Remove raining ring (35), and slowly release the spring
compression.
20.
Remove spring (36) and spacer (34) from the cylinder
block.
14-30
