TM 5-3895-383-24
(22)
Install sixteen washers (18), eight bolts (19) and nuts (20) in mounting holes of pad-foot shell halves (11 and 17). Tighten nuts
to maintain uniform gaps between shell halves along both joints.
(23)
Tighten two nuts (15) to 340 lb-ft (460 Nm).
(24)
Tighten eight nuts (20) to 340 lb-ft (460 Nm).
(25)
Remove chocks.
(26)
Start engine and raise leveling blade (TM 5-3895-383-10).
(27)
Drive Roller slowly for 1 minute.
(28)
Lower leveling blade, apply parking brake and shut engine off (TM 5-3895-383-10).
(29)
Chock wheels and drum.
(30)
Tighten eight nuts (20) to 340 lb-ft (460 Nm).
NOTE
Typically, two to four repetitions are required to seat pad-foot shell to drum assembly.
(31)
Repeat steps (24) through (28) until nuts retain tightness of 340 lb-ft (460 Nm).
NOTE
Snug, but do not tighten scraper mounting bolts until after pad-foot shell is installed and
scrapers are properly adjusted.
(32)
Install fourteen scrapers (3) on bumper assembly (6) with twenty-eight washers (2) and bolts (1). Snug, but do not tighten
bolts.
(33)
Position fourteen scrapers (3) to allow 9/16 in (15 mm) clearance between scrape tip and drum surface.
2-45
