TM 5-3895-383-24
Radiator Core - Clean
SMCS Code: 1353-070-KO
Illustration 288
Open the engine compartment.
Illustration 289
The radiator core is located at the rear of the machine.
Illustration 290
Inspect the radiator core for debris. If necessary, clean the
radiator.
Compressed air is preferred, but high pressure water or steam
can be used to remove dust and general debris from a radiator.
Clean the radiator according to the condition of the radiator.
See Special Publication, SEBD0518, "Know Your Cooing
System" for more detailed information about cleaning radiator
fins.
Close the engine compartment.
Rollover Protective Structure (ROPS) - Inspect
SMCS Code: 7323-040; 7325-040
Illustration 291
Inspect the rollover protective structure (ROPS) for any loose
bolts or damaged bolts. Replace the damaged bolts with
original equipment parts only. Tighten the bolts to a torque of
400 ± 10 N•m (295 ± 7 lb-ft).
NOTE:
Apply oil to all ROPS bolt threads before installing
the bolts. Failure to apply the oil to the threads
can result in an improper bolt torque.
Replace the ROPS mounting support if the ROPS rattles.
Replace the ROPS mounting support if the ROPS makes
noise.
Do not straighten the ROPS or repair the ROPS by welding
reinforcement plates to the ROPS.
Consult your Caterpillar dealer for the repair of the ROPS.
Maintenance Section
Radiator Core - Clean
1-119
